Independent appliance repair service. We are not affiliated with, authorized by, sponsored by, or endorsed by JennAir.
JennAir and related trademarks are the property of their respective owners.
Code F1E3 on a built-in JennAir dishwasher commonly relates to control fault. Use this page to capture the fault cleanly, try only low-risk checks, and know when to book JennAir Appliance Repair.
Reviewed by Marcus Hale · Last reviewed August 11, 2026
Written by
Marcus Hale Appliance Repair Content SpecialistPublished August 9, 2026Updated August 11, 2026Technically reviewed August 11, 2026
Reviewed Wording follows cited JennAir service literature; confirm decode on your exact model.
Paraphrased from Whirlpool-family / JennAir Product Help dishwasher F#E# patterns; confirm on your model tech sheet.
Error codeF1E3
ApplianceDishwasher
Affected model seriesJennAir built-in dishwasher — confirm your full model and serial
Quick answer
F1E3 — Control fault on a JennAir dishwasher (verify for your model).
Model compatibility: JennAir reuses codes across series and model years, so F1E3 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
In plain terms: F1E3 indicates a control-side fault. If it returns after a one-minute breaker reset, book diagnosis with your model and serial numbers. Wording and recovery steps differ by JennAir model and control generation — confirm in your use & care guide or Product Help. Guidance from JennAir Appliance Repair is independent repair help, not official JennAir service.
Signs
Symptoms you may notice
The dishwasher shows F1E3 and controls act erratically
F1E3 appears at power-on
Programs won’t start reliably with F1E3
Why it happens
Possible causes
A control-board fault
A power or wiring irregularity
A firmware or electronics glitch
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm stable power at the outlet
Perform a manufacturer-approved restart once
Record the full model number
Photograph the full code and rating-plate model/serial before any reset
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Get help
When to call a technician
If F1E3 persists after the safe checks above, contact a qualified appliance technician with your model and serial numbers. This site is independent repair guidance — not official JennAir service.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not affiliated with JennAir.
F1E3 indicates a control-side fault. If it returns after a one-minute breaker reset, book diagnosis with your model and serial numbers.
A one-time breaker reset is reasonable after safe checks. Returning F1E3 is a signal to pause homeowner experiments and schedule JennAir Appliance Repair.
Wording and recovery steps differ by JennAir model and control generation — confirm in your use & care guide or Product Help. Guidance from JennAir Appliance Repair is independent repair help, not official JennAir service.
No. JennAir Appliance Repair publishes independent repair guidance for homeowners. For manufacturer documentation use producthelp.jennair.com and your model manual — then book an independent technician if the fault continues.
