Independent appliance repair service. We are not affiliated with, authorized by, sponsored by, or endorsed by JennAir.
JennAir and related trademarks are the property of their respective owners.
F2E6 is a service-facing display on many JennAir dishwasher controls, often tied to ui / control link. Read the overview, stay within user-safe steps, and contact JennAir Appliance Repair if the message returns.
Reviewed by Marcus Hale · Last reviewed August 11, 2026
Written by
Marcus Hale Appliance Repair Content SpecialistPublished August 9, 2026Updated August 11, 2026Technically reviewed August 11, 2026
Reviewed Wording follows cited JennAir service literature; confirm decode on your exact model.
Paraphrased from Whirlpool-family / JennAir Product Help dishwasher F#E# patterns; confirm on your model tech sheet.
Error codeF2E6
ApplianceDishwasher
Affected model seriesApplies to many JennAir built-in dishwasher installations; match your docs
Quick answer
Quick take: F2E6 ≈ ui / control link for many JennAir dishwasher controls (model-dependent).
Model compatibility: JennAir reuses codes across series and model years, so F2E6 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
In plain terms: F2E6 is a UI-to-control link fault. One full power reset; book service if it returns immediately. Control generations share many JennAir / Whirlpool-family codes, but prompts and cleared-state behavior still vary. Cross-check the manual; book JennAir Appliance Repair if DIY resets do not hold.
Signs
Symptoms you may notice
The dishwasher displays F2E6 and controls respond oddly
F2E6 appears at start-up or mid-cycle
Buttons or programs behave inconsistently with F2E6
Why it happens
Possible causes
An internal control or wiring fault
A communication issue between components
A transient electronics glitch
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm stable power at the outlet
Perform a manufacturer-approved restart once
Record the full model number for the technician
Photograph the full code and rating-plate model/serial before any reset
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Get help
When to call a technician
If F2E6 persists after the safe checks above, contact a qualified appliance technician with your model and serial numbers. This site is independent repair guidance — not official JennAir service.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not affiliated with JennAir.
F2E6 is a UI-to-control link fault. One full power reset; book service if it returns immediately.
Avoid clearing codes over and over to “force” a cycle. Capture F2E6 first; if it sticks after one careful reset, let JennAir Appliance Repair test the appliance.
Control generations share many JennAir / Whirlpool-family codes, but prompts and cleared-state behavior still vary. Cross-check the manual; book JennAir Appliance Repair if DIY resets do not hold.
No. JennAir Appliance Repair publishes independent repair guidance for homeowners. For manufacturer documentation use producthelp.jennair.com and your model manual — then book an independent technician if the fault continues.
