Independent appliance repair service. We are not affiliated with, authorized by, sponsored by, or endorsed by JennAir.
JennAir and related trademarks are the property of their respective owners.
Seeing F60 on your JennAir oven? It usually points toward oven fault. This independent guide from JennAir Appliance Repair covers symptoms, cautious checks, and clear next steps — without sending you to a factory “authorized” desk.
Reviewed by Marcus Hale · Last reviewed August 11, 2026
Written by
Marcus Hale Appliance Repair Content SpecialistPublished August 9, 2026Updated August 11, 2026Technically reviewed August 11, 2026
Reviewed Wording follows cited JennAir service literature; confirm decode on your exact model.
Paraphrased from Whirlpool-family / JennAir electronic oven control (EOC) F-code patterns; confirm for your wall oven or range.
Error codeF60
ApplianceOven
Affected model seriesSeen on JennAir wall oven / range platforms (verify your rating label)
Quick answer
F60 — Oven fault on a JennAir oven (verify for your model).
Model compatibility: JennAir reuses codes across series and model years, so F60 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
What owners usually need to know: F60 is an oven F-code (control-generation specific). Reset once; book service if immediate return. Wording and recovery steps differ by JennAir model and control generation — confirm in your use & care guide or Product Help. Guidance from JennAir Appliance Repair is independent repair help, not official JennAir service.
Signs
Symptoms you may notice
The oven displays F60 during operation
F60 appears without an obvious cause
The oven behaves inconsistently with F60 shown
Why it happens
Possible causes
A sensor reading out of range
A wiring or connection issue
A control interpreting the reading as a fault
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm the appliance has stable power
Check for visible blockages or obstructions
Record the full model number
Note any leak, odor, breaker trip, or unusual heat alongside the code
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Do not adjust, disconnect or repair any gas connection or valve
Get help
When to call a technician
If F60 persists after the safe checks above, contact a qualified appliance technician with your model and serial numbers. This site is independent repair guidance — not official JennAir service.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not affiliated with JennAir.
F60 is an oven F-code (control-generation specific). Reset once; book service if immediate return.
You may clear the display once you have photographed it and completed only the manual’s user steps. Persistent F60 means diagnosis by JennAir Appliance Repair, not more DIY cycling.
Wording and recovery steps differ by JennAir model and control generation — confirm in your use & care guide or Product Help. Guidance from JennAir Appliance Repair is independent repair help, not official JennAir service.
No. JennAir Appliance Repair publishes independent repair guidance for homeowners. For manufacturer documentation use producthelp.jennair.com and your model manual — then book an independent technician if the fault continues.
