Independent appliance repair service. We are not affiliated with, authorized by, sponsored by, or endorsed by JennAir.
JennAir and related trademarks are the property of their respective owners.
For a JennAir dishwasher showing FEE6 (sensor / eeprom), start with accurate notes—not panel teardown. JennAir Appliance Repair outlines meaning, symptoms, and when an independent technician should take over.
Reviewed by Marcus Hale · Last reviewed August 11, 2026
Written by
Marcus Hale Appliance Repair Content SpecialistPublished August 9, 2026Updated August 11, 2026Technically reviewed August 11, 2026
Reviewed Wording follows cited JennAir service literature; confirm decode on your exact model.
Paraphrased from Whirlpool-family / JennAir Product Help dishwasher F#E# patterns; confirm on your model tech sheet.
Error codeFEE6
ApplianceDishwasher
Affected model seriesTypical on JennAir built-in dishwasher; always confirm generation
Quick answer
Quick take: FEE6 ≈ sensor / eeprom for many JennAir dishwasher controls (model-dependent).
Model compatibility: JennAir reuses codes across series and model years, so FEE6 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
FEE6 is a service electronics / sensor-family fault (model-dependent). Record the code and consult the tech sheet. Control generations share many JennAir / Whirlpool-family codes, but prompts and cleared-state behavior still vary. Cross-check the manual; book JennAir Appliance Repair if DIY resets do not hold.
Signs
Symptoms you may notice
The dishwasher displays FEE6 during operation
FEE6 appears without an obvious cause
The dishwasher behaves inconsistently with FEE6 shown
Why it happens
Possible causes
A sensor reading out of range
A wiring or connection issue
A control interpreting the reading as a fault
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm the appliance has stable power
Check for visible blockages or obstructions
Record the full model number
Write down the exact display string, cycle mode, and whether the fault repeats
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Get help
When to call a technician
If FEE6 persists after the safe checks above, contact a qualified appliance technician with your model and serial numbers. This site is independent repair guidance — not official JennAir service.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not affiliated with JennAir.
FEE6 is a service electronics / sensor-family fault (model-dependent). Record the code and consult the tech sheet.
Yes for a single, calm reset after user-safe checks — no for repeated clears. Recurring FEE6 belongs with an independent technician at JennAir Appliance Repair.
Control generations share many JennAir / Whirlpool-family codes, but prompts and cleared-state behavior still vary. Cross-check the manual; book JennAir Appliance Repair if DIY resets do not hold.
No. JennAir Appliance Repair publishes independent repair guidance for homeowners. For manufacturer documentation use producthelp.jennair.com and your model manual — then book an independent technician if the fault continues.
