Independent appliance repair service. We are not affiliated with, authorized by, sponsored by, or endorsed by JennAir.
JennAir and related trademarks are the property of their respective owners.
F58 is a service-facing display on many JennAir oven controls, often tied to oven fault. Read the overview, stay within user-safe steps, and contact JennAir Appliance Repair if the message returns.
Reviewed by Marcus Hale · Last reviewed August 11, 2026
Written by
Marcus Hale Appliance Repair Content SpecialistPublished August 9, 2026Updated August 11, 2026Technically reviewed August 11, 2026
Reviewed Wording follows cited JennAir service literature; confirm decode on your exact model.
Paraphrased from Whirlpool-family / JennAir electronic oven control (EOC) F-code patterns; confirm for your wall oven or range.
Error codeF58
ApplianceOven
Affected model seriesJennAir wall oven / range — confirm your full model and serial
Quick answer
JennAir oven code F58: Oven fault. Confirm in the model guide.
Model compatibility: JennAir reuses codes across series and model years, so F58 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
What owners usually need to know: F58 is an oven diagnostic indication. Confirm against model documentation. The same characters can map to different service actions across wall ovens, dishwashers, or refrigeration. Verify against your exact model docs. JennAir Appliance Repair provides independent diagnosis — not a manufacturer service agency.
Signs
Symptoms you may notice
The oven displays F58 during operation
F58 appears without an obvious cause
The oven behaves inconsistently with F58 shown
Why it happens
Possible causes
A sensor reading out of range
A wiring or connection issue
A control interpreting the reading as a fault
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm the appliance has stable power
Check for visible blockages or obstructions
Record the full model number
Note any leak, odor, breaker trip, or unusual heat alongside the code
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Do not adjust, disconnect or repair any gas connection or valve
Get help
When to call a technician
If F58 persists after the safe checks above, contact a qualified appliance technician with your model and serial numbers. This site is independent repair guidance — not official JennAir service.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not affiliated with JennAir.
F58 is an oven diagnostic indication. Confirm against model documentation.
Avoid clearing codes over and over to “force” a cycle. Capture F58 first; if it sticks after one careful reset, let JennAir Appliance Repair test the appliance.
The same characters can map to different service actions across wall ovens, dishwashers, or refrigeration. Verify against your exact model docs. JennAir Appliance Repair provides independent diagnosis — not a manufacturer service agency.
No. JennAir Appliance Repair publishes independent repair guidance for homeowners. For manufacturer documentation use producthelp.jennair.com and your model manual — then book an independent technician if the fault continues.
